In setting up the Equallogic, I ran the initial install script, it found the uninitialized drive then initialized it, then it started to run the rest of the script. It error'd out, I tried to run it again but this time it could not find an uninitialized drive because it had already initialized it so the script just stops. I tried consoling into the Equallogic management port and using the "Reset" and "DeleteAllMyDataNow" command and it wipes the drive clean of all information except for what information that still shows it being initialized. I have even tried to use the Remote setup wizard but again it can't get past the part of looking for uninitialized drives.
The question is how do I reset the Equallogic back to being uninitialized?