Hi Dell Team,
Got this error: Hope you can assist
This message was generated by the Dell EqualLogic SAN Headquarters service (version 2.5.0.6470) running on SaNHSVR
The following conditions on Group EQL (MailScanner warning: numerical links are often malicious: 150.xxx.xxx.x19) have generated an alert notification:
Warning conditions:
- 7/23/2016 1:04:26 AM to 7/26/2016 9:02:46 AM
- [ID: 1.6] The group EQL was added using non-management well known address (MWKA) address. Remove and add the group using the Group management well known address 150.xxx.xxx.x21.
- The group EQL was added using non-management well known address (MWKA) address. Remove and add the group using the Group management well known address 150.xxx.xxx.x21.
- Condition already generated an e-mail message. If the condition persists, additional messages will be sent approximately every 6 hours.
- 7/23/2016 7:16:20 AM to 7/26/2016 8:09:19 AM
- [ID: 3.23] Warning: Member EQL01-FLC network port cannot be reached. Unable to obtain network performance data for the member.
- Condition already generated an e-mail message. If the condition persists, additional messages will be sent approximately every 6 hours.
NOTE: To customize e-mail alert notification launch an instance of the SAN HeadQuarters Client then:
- Click the 'Settings' button and select 'E-Mail Settings'.
- Select the 'Notifications' tab.
- Select the group to modify.
- The top section of checkboxes allow enabling/disabling of all alerts under a specific category.
- The bottom selection contains allows enabling/disabling of individual alerts.
- Click the 'Apply' button to save the changes for this group or all groups.