Hi there,
I've enabled ISOE on partition 0 in our FC630, broadcom/qlogic 10GbE card. After configured everything on MS iscsi initator then I've seen all the paths were active for a while (10-20min) then one of the paths is just disappeared and never reconnected.
I can see "logout request was received from the initiator" message on the EQL log but that is not very helpful. Interestingly enough, this was just happened to the LUN; I've seen no issue for vss-control. So I was checking out the option and I've noticed that if I change the MPIO from "least queue depth" to "fail over only" then I dont see any path disappearance.
As I'm not quite sure why the default option "least queue depth" is not working, I'd appreciate for any insight and details.
Thanks,